Miele DAG 1000 - Manual (Page 34)

Installation with the DAG 1000
external blower
If using DAG 1000 external blower, a
connection plate much be installed on
the ventilation system instead of the
blower box.
It can be mounted on either on the front
or the rear of the appliance.
If the connection plate is mounted on
the front, the exhaust can only be
vented to the front.
If the connection plate is mounted on
the rear, the exhaust can only be
vented to the rear.
^ Plug the connector for the blower into
the socket in the housing as shown.
^ The connection plate is installed the
same way as described for the
blower box.
^ The cover is installed on the housing
on the opposite side of the
connection plate.
^ The ventilation system is connected
to the external blower by an
additional control cable. Please
follow the Operating and Installation
Instructions for the DAG 1000.
The control cable will be connected
in the terminal box of the ventilation
system (see "Electrical connection").
^ The ventilation system and the
external blower are connected by a
C 10" (254 mm) vent duct.
Installation
34