Miele DAG 1000 - Manual (Page 28)

^ Remove the screws from the
countertop.
^ Lift the appliance back out of the
cabinet.
^ Pre-drill the marked mounting holes
on the cabinet floor.
^ Tighten the mounting brackets on the
appliance at the marked position.
^ Lay the vent housing on the floor on a
blanket or other suitable protection in
order to mount the DAG 500 blower
or DAG 1000 blower adapter.
Decide on the venting direction.
If the ventilation system is installed in a
cabinet, the vent duct can go through
the floor, the right or left side, or to the
rear of the cabinet.
Installing the DAG 500 blower box on
the front
Venting to the side or downwards:
^ Plug the connection cable from the
ventilation system into the blower
motor.
^ Turn the blower box so that the vent
collar faces in the desired direction –
left, right or downwards.
^ Mount the blower box to the housing
with 4 screws.
Installation
28