Miele DAG 1000 - Manual (Page 23)

Exhaust air ducting using the DAG 500
internal blower, installed on the front of
the appliance [vent duct 6"
C
(150 mm)]:
a to the left or right, b
downwards,
c to the rear.
If the blower is being installed at the
rear of the appliance, a cut-out must be
made in the rear of the cabinet or wall
where it will be mounted and the
appropriate clearances must be
maintained behind the cabinet.
d Feed the power cord and control
cable downwards or to the rear when
using an external blower.
e Using the DAG 1000 external
blower, install exhaust ducting to the
rear (vent duct 10"
C (254 mm)).
If installing the exhaust ducting to the
front, appropriate clearances must be
maintained in the cabinet.
a) Cooktop overhang
b) Minimum width of the cooktop:
DA 6480: 28" (711 mm)
DA 6490: 34" (864 mm)
– The specified dimensions minimum
cut-out dimensions must be
observed.
– If an oven or stove is installed before
the ventilation system, read the
associated installation instructions.
Note all installation dimensions and
guidelines regarding ventilation
systems.
– Be aware of kitchen cabinets, back
splashes and/or racks in the area of
the ventilation system and the
cooktop. Ensure that the area where
the vent rises is free of obstacles.
– Make sure that any required
minimum distance between the front
edge of the countertop and the front
edge of the cooktop is maintained.
– If there is a drawer in the way, it must
be shortened or removed. The front
panel of the drawer could also be
installed to permanently cover the
drawer cut-out.
Appliance dimensions
23