Mercedes-Benz 2005 G 500 - Manual (Page 210)

210
Controls in detail
Useful features
If you live in Canada or if you are having dif-
ficulties programming a gate operator (re-
gardless of where you live) by using the
programming procedures, replace step 4
with the following:
Step 4:
̈ Continue to press and hold the inte-
grated signal transmitter button (
2,
3 or 4) while you press and re-press
(“cycle”) your hand-held remote con-
trol transmitter
6 every two seconds
until the frequency signal has bee-
learned. Upon successful training, the
indicator lamp
1 will flash slowly and
then rapidly after several seconds.
̈ Proceed with programming step 5 and
step 6 to complete.
Operation of integrated remote control
̈ Switch on the ignition ( ୴ page 35).
̈ Select and press the appropriate inte-
grated signal transmitter button (
2,
3 or 4) to activate the remote con-
trolled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.
Erasing the integrated remote control
memory
̈ Switch on the ignition ( ୴ page 35).
̈ Simultaneously hold down the signal
transmitter buttons
2 and 4, for ap-
proximately 20 seconds, until the indi-
cator lamp
1 blinks rapidly. Do not
hold for longer than 30 seconds.
The codes of all three channels are
erased.
Reprogramming a single integrated sig-
nal transmitter button
To program a device using a signal trans-
mitter button previously trained, follow
these steps:
̈ Press and hold the desired signal trans-
mitter button (
2, 3 or 4). Do not re-
lease the button.
̈ The indicator lamp will begin to flash af-
ter 20 seconds. Without releasing the
integrated signal transmitter button,
proceed with programming starting
with step 3.
i
If you sell your vehicle, erase the codes
of all three channels.