To meridian 500 series equipment, Meridian 500 series operation, setting, For 500 series operation – Meridian America 506 User Manual

Page 23

Setting up the CD player

To connect to other Meridian 500
Series equipment

●

Connect one of the COMMS sockets on the back panel of the

CD player to one of the COMMS socket on another 500 Series

unit, using the 500 comms lead provided with the other unit.

The sequence in which you connect the units is not important.

COMMS

Then configure the units with the following automatic setup

procedure:

●

Switch all the units to standby.

●

Press Clear on the remote.

Each unit will display:

Auto

One unit will then be designated

as the controller, and display:

Con.

This is the unit that will respond to the remote.

All the other units will be configured

as non-controllers, and display:

N.Con.

Your system is now set up and ready for use.

●

If for any reason the automatic setup does not give the

configuration you want, restore the default operation by

Note: Do not, under any circumstances, connect any equipment

other than Meridian 500, 600, or 200 Series to the socket

marked COMMS on the back of the CD player.