Magellan 310 - Manual (Page 66)

Reference
Turning the Beeper On/Off — Allows you to select which actions will
cause the beeper to sound. You can choose from Off, Keys Only
(pressing a key causes a beep), Alarms Only (when an alarm is activated)
or Keys & Alarms.
Any
MENU Highlight
Setup
Highlight
Beeper
Select
Beeper
ENTER
ENTER ENTER From
Screen
Options
Default: Keys & Alarms
Selecting NMEA Message — Allows the selection of the NMEA message
that will be output from the Meridian. Choices are Off, V1.5 APA,
V1.5 XTE or V2.1 GSA. Your choice will be dependent upon what
message the device you are connecting to needs to receive.
Any
MENU Highlight
Setup
Highlight
NMEA
Select
NMEA
ENTER ENTER
ENTER
From
Screen
Message
Default: Off
Selecting the Baud Rate — Enables you to set the baud rate of the data
being sent out from the Meridian’s output port. The baud rate sent out
must match the baud rate that the receiving device is set for. You can
choose from 1200 baud, 4800 baud, 9600 baud, 19200 baud, 57600
baud or 115200 baud.
Any
MENU Highlight
Setup
Highlight
Baud Rate
Select
Baud
ENTER
ENTER ENTER From
Screen
Rate
Default: 4800 Baud
56 Magellan Meridian GPS Receiver