Metra Electronics 99-1005 - Manual (Page 6)

4
99-1005 KIT ASSEMBLY
B
C
D
A
ISO MOUNT RADIO WITH POCKET PROVISION
Mount the rear support bracket to
the back of the pocket using the
remaining (2) screws supplied with
the kit. (Figure A) 2
Mount the ISO Brackets to the after-
market radio using the screws sup-
plied with the radio. (Figure B) 3
Slide the radio into the radio open-
ing until the side clips snap into
place. (Figure C) 4
Snap the trim plate onto the front of
the Radio Housing. (Figure D) 5
Continue to final assembly.
Note:
To remove the radio from the
radio housing, unclip and remove
ISO trim-plate. Then use a small
flat blade screw driver to release
the ISO snap in brackets and slide
the radio out of the radio housing.
* Note: Refer also to the instructions included with the aftermarket radio.
Mount the pocket to the back of the
radio housing using (2) of the screws
supplied with the kit. (Figure A) 1