Important – MSI NVIDIA MS-7504PV User Manual

Page 18

MS-7504 Mainboard

2-6

10. Align the holes on the mainboard

with the heatsink. Push down the

cooler until its four clips get

wedged into the holes of the

mainboard.

12. Turn over the mainboard to con-

firm that the clip-ends are cor-

rectly inserted.

11. Press the four hooks down to fas-

ten the cooler.

Then rotate the lock-

ing switch (refer to the correct di-

rection marked on it) to lock the

hooks.

9. Press down the load lever lightly

onto the load plate, and then se-

cure the lever with the hook under

retention tab.

locking

switch

1. Whenever CPU is not installed, always protect your CPU socket pin with the

plastic cap covered (shown in Figure 1) to avoid damaging.

2. Mainboard photos shown in this section are for demonstration of the CPU/

cooler installation only. The appearance of your mainboard may vary de-

pending on the model you purchase.

Important