MITSUBISHI ELECTRIC X100 - Manual (Page 52)

52
PROBLEMS CAUSE POSSIBLE SOLUTIONS
The image
remains blurred. • When you see the stationary image for a long time, it may remain on the screen if
you change the image. It is not a breakdown. The blurred image will disappear in a
few minutes.
Red, blue or green
dots are viewed on
the text of image.
• It is normal.
The image is
distorted on the
screen and
noise is heard.
No sound is
heard.
• Volume is not turned up.
• Mute function on PCGC is on.
• Connection to other equipment is not
made correctly.
• Turn up the volume.
• Cancel the mute function. See page 30.
• Check connections.
See page 21.
Nothing is
displayed on
the PC monitor. • The PC monitor is not turned on. • Turn on the monitor.
Warm air comes out
of the exhaust vents. • This is typical of the LCD projector.
Adjustments cannot
be made. • The operation is incorrectly made due
to noise or interference.
• Reset the mode and try again.
• The cable for connection with other
equipment is not plugged securely
into the terminal.
• The projector is installed too close to
other equipment.
• Plug the connecting cable securely into the
terminal. See pages 17-21.
• Install the projector far away from other
equipment.