MITSUBISHI ELECTRIC X100 - Manual (Page 35)

35
Super impose (Picture in Picture)
One of the special features of this unit is the picture-in-picture (PinP) mode. PinP allows you to view
different sources at the same time. The sub image will become a still picture.
1. Press the PinP button on the remote control. Pressing the PinP button repeatedly will select on
and off.
• In PinP mode, the sound will be switched off.
• When the main image is set to PC1 or PC2, the main and sub image will become still pictures.
• When the main image and sub image are set to RGB1, RGB2, VIDEO1 or VIDEO2, the sub image
is recaptured by pressing the ‘-’ button.
• When the sub image is set to PC1 or PC2, the sub image is not recaptured by pressing the ‘-’
button.
• The sub image may vibrate. If this is the case, select the image again by pressing the ‘-’ button.
• The super impose function won’t work if there isn’t an input signal.
• You can change the input source, the frame position and the frame size by using the on-screen
menu.
• You can change the input source of the PinP image by pressing the ‘+’ button.
• Pressing the
ª or º buttons on the control panel (or { or } buttons on the remote control),
the main image will be in still mode and the sub image starts moving. Pressing the button again
will resume display.
• In PinP mode you cannot adjust the zoom/focus.