Minolta PCL6 - Manual (Page 45)

4. Setup tab
3-13
P
rop
er
ti
es
Se
tt
in
gs
Ch
apte
r 3
(2) Punch (when the Punch Unit is installed to the Finisher/Booklet Finisher)
Allows you to punch holes in the printed document.
• Off
The document is not punched.
• Upper The document is punched along the upper side.
• Left The document is punched along the left side.
• Right The document is punched along the right side.
(3) Folding (when FN-7 and ZK-2 are installed)
Allows you to select the desired paper folding function.
• Off
Printed pages are not folded.
• Z-folding Printed pages are folded into three parts with the
printed surface inside.
• Fold Printed pages are folded once with printed surface
inside.
• Center Staple + Fold Printed pages are stapled at the center and creased
with printed surface inside.
(4) Cover Sheet Mode (when Cover Inserter C is installed)
• Off Cover sheets are not inserted.
• Front Cover sheets are inserted in front of your job.
• Back Cover sheets are inserted in the back of your job.
• Front and Back Cover sheets are inserted at both the front and back of
your job.
(5) Trimming (when the Trimmer Unit is installed to the Booklet Finisher)
Specify if you want to trim the pages of your booklet.
• Off
The document is not trimmed.
• On The document is trimmed.