Mitsumi electronic C10 SERIES - Manual (Page 8)

8 1. Setup and Operation
For assistance call 1(800) 332-2119
Tun ing Channels from the Antenna Input
After performing a channel scan, use these methods to
tune to channels on the ANT input. Channels can be
either from an over-the-air antenna or from direct cable
service.
Enter the channel number using the number keys •
on the remote control and press ENTER.
Include the sub-channel when tuning digital chan- •
nels. For a two-part digital channel, such as 3-1,
press 3
—
CANCEL 1 ENTER.
Press • CH / to change channels one channel
at a time.
Press and hold • CH / to speed through chan-
nels.
Press • LAST to return to the previous channel.
Use the Fav (Favorites) feature to tune to up to nine •
favorite channels. See page 10 .
Using an External Sound System
To switch from the internal TV speakers to an external
sound system:
Press 1. MENU.
Display the 2. Sound > TV Speaker option.
Press 3. ENTER to switch between ON and OFF..
Additional audio controls are in the Sound menu, page
21 .
Picture Settings
To get the best picture under dif- 1.
ferent viewing conditions, set the
Picture Mode first before changing
other video settings. See page 20 .
a. Press VIDEO multiple times to select
one of these Picture Modes:
Name When to Use
Brilliant Under bright light
Bright For most daytime viewing
Natural For most nighttime viewing
Game With gaming consoles
b. Press ENTER to confirm your selection.
Wait a few seconds for 2. the display to clear.
Additional picture options are available in the Picture
menu, page 20 .
Naming
Assign helpful names to TV inputs.
Press 1. MENU.
Go to the 2. Setup > Input > Input Name menu.
In the inputs list, highlight the input to change and 3.
press ENTER.
Highlight a name in the name list. 4.
Press 5. ENTER to confirm
the name.
Press 6. EXIT to clear
menus.
Removing
To remove unused inputs from the input list,
Switch to an input other than the one you are 1.
removing.
Go to the name list for the input as described 2.
above.
Highlight 3. Skip this input and press ENTER.
Press 4. EXIT to clear menus.
Selecting an Input to Watch
Press the INPUT key to select a TV input to watch. Use
the Setup > Input menu to rename, add, or remove
inputs from the list.
TV I nputs