Metra Electronics CK-612MI - Manual (Page 5)

8
Disconnect the negative battery terminal to
prevent an accidental short circuit. Unclip
the gear shifter trim panel and remove.
Remove (2) Phillips screws exposed at the
base of the dash trim bezel. Unclip the dash
trim bezel. Remove (4) Phillips screws
securing the factory head unit and
disconnect the wiring.
1
MITSUBISHI Galant 1994-98
2
Cut and remove mounting tabs "A" and "B"
on the Radio Housing. Cut and remove all
mounting tabs on Bracket Set #1 EXCEPT
tabs "D". The mounting tabs can be
identified by the stamped letter on the back
of each tab.
"D"
"D"
3
Cut and remove the lower rib from the radio opening.
Skip to the Installation Instructions for ALL VEHICLES on
Page #12.
"D"
9
Disconnect the negative battery terminal to
prevent an accidental short circuit. Pry out
on the top of the dash trim bezel and remove
the bezel. Remove (4) screws securing the
factory head unit and disconnect the wiring.
1 2
"C"
"C"
3
DASH TRIM BEZELS WITH A DIVIDED RADIO OPENING: If keeping the factory pocket is
NOT desired, cut and remove the upper rib from the radio openingand snap the Filler Bar
onto the bottom of the Radio Housing. (see Fig. A). If keeping the factory pocket is desired,
cut and remove the upper rib from the radio opening and the bottom portion of the Radio
Housing. (see Fig. B). Skip to the Installation Instructions for ALL VEHICLES on Page #12.
DASH TRIM BEZELS WITH AN UNDIVIDED RADIO OPENING: If keeping the factory
pocket is NOT desired, cut and remove the lower rib from the radio opening and the top portion
of the Radio Housing. (see Fig. C). If keeping the factory pocket is desired, cut and remove
the lower rib from the radio opening, the top portion of the Radio Housing and the bottom
portion of the Housing. (see Fig. D). Skip to the Installation Instructions for ALL VEHICLES on
Page #12.
Fig. A
Fig. B
Fig. C
Fig. D
MITSUBISHI Mirage 1997-00
Cut and remove mounting tabs "A" and "B"
on the Radio Housing. Locate mounting
tabs "C" on Bracket Set #1. The mounting
tabs can be identified by the stamped letter
on the back of each tab.