Miele G7859 - Manual (Page 52)

Drainage
The drainage system is fitted with a
non-return valve which prevents dirty
water from flowing back into the
machine.
The machine should preferably be
connected to a separate drainage
system on-site.
If no separate drainage system is
available, contact the Miele Service
Department.
The on-site drain connection point
should be located between 0.3 m
and 1 m above the lower edge of the
machine.
If the connection is lower than 0.3 m,
the hose should loop at a height
of at least 0.3 m to ensure correct
drainage.
The drainage system must have the
capacity to take a minimum drainage
flow of 16 litres/minute.
The machine is supplied with
approx. 1.4 m of flexible drain hose
with an internal diameter of 22 mm.
Two hose clips are also supplied for
connection.
The drain hose must not be shortened.
A longer drain hose (up to 4 m long)
is available to order from the Miele
Spare Parts Dept.
The drainage system must not ex-
ceed 4 metres.
See also the installation diagram
supplied.
Plumbing
48