Miele G7859 - Manual (Page 47)

Water in the wash cabinet is not
heated; the programme sequence
lasts too long
This machine has a resettable thermal
cutont which will switch off the heaters
in the case of overheating. This could
be caused, for example, if large articles
cover the heating elements or if the fil-
ters in the wash cabinet are blocked.
Remove the cause of the fault.
Take off the service panel (see “Elec-
trical connection”).
Press the reset button on the heater
limiter (yellow) located on the left
hand side of the plastic cover.
If this switch trips again, the Miele
Service Dept. must be contacted.
After Sales Service
Should you still have any difficulties or
if the fault code “F...” shows in the dis-
play field please contact your auth-
orised Service Dealer or the Miele Ser-
vice Department.
See back cover for addresses.
Please quote the fault code “F...” as
well as the model type and number
of your machine.
This information can be found on the
data plate inside the door (see also
“Electrical connection”).
Please note that telephone calls
may be monitored and recorded to
improve our service.
Correcting minor faults
43