Motorola DSR500 - Manual (Page 5)

5
to the telephone line. Excessive REN’s on the telephone line may result in the
devices not ringing in response to an incoming call. In most, but not all areas,
the sum of the REN’s should not exceed five (5.0). To be certain of the number
of devices that may be connected to the line, as determined by the total REN’s
contact the telephone company to determine the maximum REN for the calling
area.
This equipment cannot be used on the telephone company-provided coin
service. Connection to party line service is subject to state tariffs.
If this equipment causes harm to the telephone network, the telephone company
will notify you in advance that temporary discontinuance of service may be
required. If advance notice isn’t practical, the telephone company will notify you
as soon as possible. Also you will be advised of your right to file a complaint with
the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment,
operations, or procedures that could affect the operation of the equipment. If this
happens, the telephone company will provide advance notice in order for you to
make the necessary modifications in order to maintain uninterrupted service.
If trouble is experienced with this equipment, please contact:
Star Choice
1 888 554-STAR
If the trouble is causing harm to the telephone network, the telephone
company may request you to remove the equipment from the network until
the problem is resolved.
This equipment uses the following USOC jacks: RJ11C
It is recommended that the customer install an AC surge arrester in the AC
outlet to which this device is connected. This is to avoid damaging the
equipment caused by local lightening strikes and other electrical surges.
This equipment is Hearing-Aid Compatible (HAC).
The telephone consumer Protection Act of 1991 makes it unlawful for any
person to use a computer or other electronic device, including fax machines, to
send any message unless such message clearly contains in a margin at the top
or bottom of each transmitted page or on the first page of the transmission, the
date and time that it is sent and an identification of the business or other entity,
or other individual sending the message and the telephone number of the
sending machine or such business, other entity, or individual. (The telephone
number provided may not be a 900 number or any other number for which
charges exceed local or long-distance transmission charges.)
User Instructions
If this equipment does cause interference to radio or television reception,
which can be determined by turning the equipment off and then on, the user is
encouraged to try to correct the interference by one of rmore of the following
measures:
Reorient or relocate the receiving antenna.
Increase the distance between the equipment and receiver.
Connect the equipment into a different outlet so that the equipment and receiver
are on different branch circuits.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by Motorola could void the
user’s right to operate the equipment and/or the equipment warranty.
Eqiupment Attachment Limitations
Note: This product was FCC approved under test conditions that included the
use of shielded I/O cables and connectors between system components. To
comply with FCC regulations, the user must use shielded cables and
connectors and install them properly.
CP-01, Part 1, Section 10.1
“NOTICE: The Canadian Department of Communications label identifies
certified equipment. This certification means that the equipment meets certain
telecommunications network protective, operational and safety requirements.
The Department does not guarantee the equipment will operate to the user’s
satisfaction.
Before installing this equipment, users should ensure that it is permissible to be
connected to the facilities of the local telecommunications company. The
equipment must also be installed using an acceptable method of connection. In
some cases, the company’s inside wiring associated with a single line individual
service may be extended by means of a certified connector assembly
(telephone extension cord). The customer should be aware that compliance