beautypg.com

Motorola DSR500 User Manual

Page 4

background image

4

Programming Copyright Notice

Use of this device may violate Section 605 of the Communications Act of
1934, as amended, if that use consists of the unauthorized interception and
divulgence of radio communications for one’s own benefit where there is no
entitlement to its receipt.

Changes or modifications to this device not expressly approved by the party
responsible for compliance with FCC regulations (the manufacturer) could void
the user’s authority to operate the equipment.

Resale of signals received from broadcast satellites is explicitly regulated. In any
use or application involving resale or distribution, the user should verify
compliance with current laws, regulations, and approved procedures for use.
Where required, local and federal licensing or franchise authorization is the sole
responsibility of the user.

Export of this device requires a valid export license issued by the U.S.
Department of Commerce.

FCC-Required Notification of Service

The Instant Pay-Per-View system is designed to be used on standard device
telephone lines. The Instant Pay-Per-View connects to the telephone line by
means of a standard jack called the USOC RJ11C. Connection to telephone
company-provided coin service (central office implemented systems) is
prohibited. Connection to party line service is subject to State tariffs.

Telephone Company Procedures

In order for your telephone company to provide service to you, it may occasion-
ally be necessary for them to make changes in their equipment, operations, or
procedures. If these changes affect your service or the operation of your
equipment, the telephone company should give you notice, in writing, to allow
you to make any changes necessary to maintain uninterrupted service.

If you have any questions about your telephone line, such as how many pieces
of equipment you can connect to it, your telephone company should provide this
information upon request.

In certain circumstances, it may be necessary for your telephone company to
request information from you concerning the equipment which you have

connected to your telephone line. Upon request of your telephone company,
provide the FCC registration number and the Ringer Equivalence Number
(REN) of the equipment which is connected to your line; both of these items are
listed on the equipment label. The sum of all the REN’s on your telephone line
should be less than five in order to assure proper service from your telephone
company. In some cases, a sum of five may not be usable on a given line.
NOTE: The REN for the Digital Entertainment Receiver with Instant Pay-Per-
View is 0.3B.

If Problems Arise

If any of your telephone equipment is not operating properly, you should
immediately remove it from your telephone line, as it may cause harm to the
telephone network. If your telephone company notes a problem, they may
temporarily discontinue service. When practical, they will notify you in advance
of this disconnection. If advance notice is not feasible, you should be notified as
soon as possible. When you are notified, you should be given the opportunity to
correct the problem and informed of your right to file a complaint with the FCC.

FCC Compliance

This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.

FCC Part 68

This equipment complies with Part 68 of the FCC rules. Located on the
equipment is a label that contains, among other information, the FCC
registration number and Ringer Equivalence Number (REN). If requested, this
information must be provided to the telephone company.

The REN is used to determine the quantity of devices which may be connected