Motorola DSR500 - Manual (Page 10)

10
Connecting Your DSR
Make sure that the satellite receiver is not plugged into a power source before you connect
any cables to the receiver. First connect the satellite input from your satellite dish to your
receiver.
There are several way to connect your DSR to your television or monitor and other home
theater components.
Video: Utilize the modulated RF output (good), Composite video output (better), S-Video output
(best for standard definition), or Component video outputs (best for high definition) to connect
the DSR directly to your television, VCR, and home theater A/V receiver.
Audio: The modulated RF output also provides audio along with video to televisions or VCRs
(good). Utilize the stereo audio output (better) or the electrical or optical Digital audio outputs
(best) to connect the DSR directly to your television, VCR, and home theater A/V receiver.
PPV: Connect the telco phone jack to a home telephone jack for Instant Pay-Per-View (IPPV)
reportback. Star Choice will not permit IPPV unless this remains connected.
Connect the external antenna input if applicable for local off-air TV broadcast.
Plug the DSR power cord into a standard power outlet. Wait one minute, and then press the ON
key located on the left side of the satellite receiver’s front panel.
IR
Blaster
VCR
Cable
TV or
Coaxial
S-Video