Mercedes-Benz 2005 CLK 320 - Manual (Page 153)

152
Controls in detail
Control system
Setting daytime running lamp mode
(USA only)
̈ Move the selection marker with
button
æ or ç to the Lighting
submenu.
̈ Press button j or k repeatedly
until the message Lamp circuit
headlamp appears in the multifunction
display.
The selection marker is on the current
setting.
̈ Press button æ or ç to select
manual operation ( manual ) or daytime
running lamp mode ( constant ) activat-
ed.
With daytime running lamp mode activated
and the exterior lamp switch in
position
M or U the low beam
headlamps are switched on when the
engine is running.
In low ambient light conditions the
following lamps will switch on additionally:
ț Parking lamps
ț Tail lamps
ț License plate lamps
ț Side marker lamps
For more information on the daytime run-
ning lamp mode, see “Lighting”
(
୴ page 122).
i
This function is not available in
countries where the daytime running
lamp mode is mandatory and therefore
in a constant mode.
i
If you turn the exterior lamp switch to
another position, the corresponding
lamp(s) will switch on.
For safety reasons, resetting the
Lighting submenu to factory settings
( ୴ page 143) while driving will not
deactivate the daytime running lamp
mode.
The following message appears in the
multifunction display:
Lighting – Cannot be completely
reset to factory settings while
driving
.