Philips Magnavox MBP110V/F7 - Manual (Page 26)

26 EN
PLAYBACK
You can adjust the picture quality.
1 During playback, press [MODE] repeatedly
until “
“ appears.
2 Use [K / L] to select your desired item, then
use [0 / 1] to adjust the setting.
■ Black level
You can adjust the black level setting to make the black
parts of the pictures as bright as you prefer. You can select
“On” or “Off”.
■ Noise reduction (DVD-video only)
Reduces the noise of the playback picture.
3 Press [RETURN] to exit.
You can enjoy stereophonic virtual space through your
existing 2 channel stereo system.
1 During playback, press [MODE] repeatedly
until “
” appears.
2 Use [K / L] to select your desired setting.
3 Press [RETURN] to exit.
Some BD-videos have the PIP function which enables you
to display the secondary video in the primary video. You
can call up the secondary video by pressing [MODE]
whenever the scene contains the secondary video.
Refer also to the “Note” on the next page.
1 During playback, press [MODE] repeatedly
until the PIP function appears.
2 Use [K / L] to select the secondary video you
want.
• The secondary video will be displayed and the
secondary audio will be output.
• Use [0 / 1] to switch between current setting and
“Off”.
3 Press [RETURN] or [MODE] to remove the PIP
information.
Adjusting the Picture
“On” : Makes the dark parts brighter.
“Off” : Shows the original picture as recorded.
“Off” : Shows the original picture as recorded.
“1”
: Executes 3D noise reduction which detects and
deletes the noise by comparing each picture
frame.
“2” : Executes MPEG noise reduction which reduces
the block noise and mosquito noise on the
movie subtitle.
“3” : Executes both MPEG noise reduction and 3D
noise reduction.
Note
• The setting will remain the same even if the unit is
turned to the standby mode.
• For the picture output from HDMI OUT jack, “Black
Level” is not effective.
• You cannot adjust the setting during rapid playback.
Black Level
Noise Reduction
On
Off
e.g.) DVD-video
Virtual Surround
“Off” : No surround effect
“1”
: Natural surround effect
“2” : Stronger surround effect
Note
• Set the virtual surround setting to “Off” or lower the
volume if the sound is distorted.
• Virtual surround does not function during rapid
playback.
• For the virtual surround, audio signal will always be
2-channel LPCM.
PIP (BONUSVIEW) Setting
Off
primary
video
secondary
video
E8M00UD_EN.book Page 26 Thursday, July 15, 2010 10:01 AM