MITSUBISHI ELECTRIC Trium 110 - Manual (Page 37)

Th
e
m
en
u
37
can not turn it on or off.
To change the PIN2 code:
PUK code
Only your service provider can
give you the 8 digit PUK (PIN un-
block key). Use it to 'unblock' a
PIN whose code has been entered
incorrectly three times. A PUK
code cannot be changed.
Enter the PUK code and press
OK . Enter a new PIN code by
following the displayed prompts.
PUK2 code
Only your service provider can
give you the 8 digit PUK2. Use it
to unblock a PIN2 whose code has
been entered incorrectly three
times. You cannot change the
PUK2 code.
Enter the PUK2 code. Enter a new
PIN2 code by following the dis-
played prompts.
Time & date setting
To set the current time and/or
date:
Default (factory) settings
Use the Settings menu to return
to the factory settings. This does
not affect the phone book en-
tries, phone lock code or SIM.
The following are the factory de-
fault settings:
Press . Select Settings .
Select Phone settings . Select
Security .
Select PIN2 change and fol-
low the display prompts.
Press
OK to validate your
new PIN2 code.
Press and hold
Exit or
to return to the stand-by dis-
play.
If you enter the wrong PUK code 10 times in suc-
cession your SIM card cannot be used again. Con-
tact your service provider for a new card.
If you enter the wrong PUK2 code 10 times in suc-
cession you are unable to use the features requir-
ing the PIN2 code. Contact your service provider for
a new card.
Press . Select Settings .
Select Phone settings . Select
Time & date .
1
2
3
4
5
1
2
Select Set time or Set date .
Enter the time (in 24 hour
format) or date in the format
shown. (If required use
and )
Press
OK to validate your
entry.
Press and hold
Exit or
to return to the stand-by dis-
play.
1. An error message appears if you make a wrong
entry.
2. The time/date are displayed when the phone is
on. It does not show the year.
3. You may have to re-enter the time and date if
the battery was taken out.
Press . Select Settings .
Select Phone settings . Select
Default settings .
Select Yes or No .
Press and hold Exit or
to return to the stand-by dis-
play.
Feature Factory setting
Alert Tones Ring
Ring Tones Trium
Volumes ,
Ring , Key ,
Speech and
Alarm .
Mid values
Backlight and
Contrast
On for 10 sec. and
mid value
Any Key ,
Auto-Retry
and Auto An-
swer fea-
tures.
Off
Ramping Off
Menu graph-
ics
Trium
3
4
5
6
1
2
3
4