Metz Plasma-TV-Set - Manual (Page 78)

78
32. Connecting Headphones
31. Operation without the
Remote Control
Operation without the remote control is provided
as an emergency measure in case the batteries of
your remote control are exhausted or the remote
control is not readily available.
The local controls are located on the bottom
edge of the TV set, on the right.
Switching on
Press the main power switch on the TV set. After
about five seconds, the TV set is switched on with
programme position 1 or the programmed initial
programme position selected.
You can also use the following functions directly
on the TV set, without a remote control. For func-
tions which require further adjustments, the func-
tion remains preselected for ten seconds.
Programme selection
Press the -/+ buttons.
Volume
Press and hold the preselection key F until the bar
display for the volume appears on the screen. Then
press the "-" or "+" button to adjust the volume.
Contrast
Press and hold the preselection key F until the bar
display for the contrast appears on the screen. Then
press the "-" or "+" button to adjust the contrast.
The headphone socket is located behind a flap on
the left side of the TV set (see Section 35).
We recommend the use of headphones with an
impedance of at least 32
Ω. The use of headpho-
nes with a lower impedance will reduce the dyna-
mic range of the sound.
You can save the headphone volume as a stan-
dard value.
605 47 2029.A2 LCD-GB 10.03.2006 8:53 Uhr Seite 78