MITSUBISHI ELECTRIC 838 SERIES - Manual (Page 72)

72 6. NetCommand Control of an A/V Receiver (838 Series)
For assistance call 1(800) 332-2119
Automatic Audio/Video Switching Over an
HDMI Connection
If your A/V receiver has an HDMI output, it may be
convenient to send video to the TV over a single HDMI
cable through the A/V receiver. The following setup
enables the A/V receiver to switch automatically to the
correct input when you select a device in the TV’s
Input
Selection menu. Depending on the capabilities of the
A/V receiver, the connected source devices can be
analog, digital, or a mixture or the two.
VCR with
Analog Audio Output
A/V Receiver
HDMI
Output
HDMI
Cable
Connections of
any type
Blu-ray player
DVD player
Cable box
VCR
TV
Use NetCommand to switch an A/V receiver
automatically to the correct audio and video inputs for
a device (available only with an HDMI output to the TV
as shown).
Setting Up A/V Receiver Control, continued
More About Using an HDMI Connection
• Audio from devices connected directly to the
TV can be heard from the TV speakers only.
To send audio to the A/V receiver from such
devices, use one of the optional audio con-
nections shown in the diagram on the oppo-
site page. For example, use an optional audio
connection if you wish to use the A/V receiver
speakers to hear audio from:
- The ANT input
- A game or camcorder connected directly
to the TV.
• To use NetCommand to supplement HDMI
control of a CEC-enabled A/V receiver, the
recommended setup sequence is:
1. Connect the HDMI cable.
2. Enable HDMI control (New Device Found
screen).
3. Connect the secondary digital audio
cable, if desired.
4. Perform NetCommand setup.
If you perform A/V receiver NetCommand
setup first and then later connect an HDMI
cable, the NetCommand setup will be lost.
• In some cases, audio from a device connected
to the A/V receiver may not be passed over the
HDMI cable to the TV speakers. In these cases
you must use the A/V receiver speakers to hear
audio.