Mercedes-Benz 2004 C-Class Wagon - Manual (Page 70)

70
Safety and Security
Occupant safety
Installation of infant and child restraint
systems
Anchorage rings 1 are located on the
back side of the outer rear backrests and
on the floor behind the rear center seat.
1 Anchorage ring
2 Hook
Prior to installing a tether strap, note the
following steps:
̈ Roll up retractable luggage cover and
partition net.
̈ Fold the rear backrest forward
(
୴ page 211).
̈ Guide top tether strap between head
restraint and top of seat back.
Head restraints must be installed (if re-
movable) and positioned such that the
top tether strap can pass freely
between the head restraint and top of
the seat back.
Make sure the tether strap is not twist-
ed.
̈ Fold the rear backrest back until it
locks in place (
୴ page 212).
1 Anchorage ring
2 Hook
̈ Fold up anchorage ring 1.
̈ Securely fasten hook 2, which is part
of the tether strap, to anchorage
ring 1.
i
If the top tether strap is to be installed
on the left back side of the rear back-
rest, you must first remove the
twin-reel roller blind (
୴ page 210).
The tether strap has to run through the
locking mechanism of the twin-reel
roller blind.
Warning!
G
Always lock backrest in its upright position
when rear seat bench is occupied by pas-
sengers, or the extended cargo area is not in
use. Check for secure locking by pushing
and pulling on the backrest.