beautypg.com

For mitsubishi dealers and service personnel only – MITSUBISHI ELECTRIC WS-55815 User Manual

Page 89

background image

88

89

Appendix H: Cabinet Separation for Model WS-65815

Front Glossy Panel

Speaker Grille

Plastic Cover (Screw)

Connector (LF-ZF)

Lower Bracket (Screw)

Front Board (Screw)

3

2

1

5

8

7

6

4

Cabinet-Top

Bracket

Interlock Tabs

Lower Rear Surface

Cabinet-Top

Cabinet-Top

(Apply force here)
If needed.

Cabinet-Bottom

2" Approximately.

1. Remove Speaker Grille by pulling forward from

left and right sides of TV.

2. Remove Front Glossy Panel screws

at lower brackets.

3. Slide Front Glossy Panel to right

side approximately 1/2", then pull
away from TV.

4. Remove the screws attaching Cabinet-Top and

Cabinet-Bottom from the front boards.

5. Disconnect the connector (LF-ZF).

6. Remove the decorative Plastic Cover on each

side of the cabinet. Remove the exposed Screw
on each side.

7. Secure the Cabinet-Bottom from moving, then slide

forward the Cabinet-Top (may require some added force).

Carefully lift the Cabinet-Top straight up until the interlock
Tabs are clear from Cabinet-Bottom.

8. Carefully place lower rear surface of Cabinet-Top on floor.

9. Once you have moved and positioned

the Cabinet-Bottom to its desired location,
reverse the procedure and mount the Cabinet-Top
on the Cabinet-Bottom . Be sure to align the
Brackets properly. KEEP FINGERS CLEAR OF ALL
JOINTS! Replace the Screws and decorative Plastic
Covers that were removed in step 6. Rejoin the
connectors per step 5. Replace the screws per step 4.
Reinstall the Glossy Panel and Screws per step 2.
Reinstall the Speaker Grille per step 1.

The following operations should be performed by two people:

The Mitsubishi TV model WS-65815 projection television cabinet has been assembled in two pieces. These
pieces may be separated to allow for easier delivery and setup. The instructions below show how to safely
separate and reattach the cabinet.
This projection television weighs over 249 pounds and has many sensitive components. This dismantling
procedure should be done by authorized Mitsubishi Dealers or Service Personnel ONLY.

For Mitsubishi Dealers and Service Personnel Only

This manual is related to the following products: