MITSUBISHI ELECTRIC WS-55815 - Manual (Page 16)

16 17
Separate UHF and VHF Antennas
Figure 4
A UHF/VHF combiner is required. This is not included with
the TV.
1. Connect the UHF and VHF antenna leads to the
UHF/VHF combiner.
2. Push the combiner onto ANT-1 MAIN on the TV
back panel.
External
Antenna
or Cable
Back Side
Flat Twin Lead
UHF Antenna
(Channels 14-69)
VHF Antenna
(Channels 2-13)
300 Ohm to
75 Ohm
Combiner
Flat Twin Lead
UHF
VHF
TV back panel (section detail)
IEEE1394
INPUT/OUTPUT
DIGITAL AUDIO
CableCARD SLOT
ANT-2
AUX
ANT-1
MAIN
– (DTV/CABLE /VHF/UHF) –
1.
2.
Figure 4. Connecting separate UHF and VHF Antennas
Connecting a Single Analog Antenna or Separate UHF and
VHF Antennas
Single Antenna
(not for use with CableCARD™)
Figure 3
A 300-Ohm to 75-Ohm transformer is required. This is not
included with the TV.
For antennas with twin flat lead
1. For antenna with twin flat leads, connect the
300-Ohm twin leads to the 300-Ohm to 75-Ohm
transformer.
2. Push the 75-Ohm side of the transformer onto ANT-1
MAIN on the TV back panel.
For antennas with coaxial lead
3. Connect the coaxial lead directly to ANT-1 MAIN on
the TV back panel.
IEEE1394
INPUT/OUTPUT
DIGITAL
AUDIO
CableCARD TM SLOT
ANT-2
AUX
ANT-1
MAIN
– (DTV/CABLE /VHF/UHF) –
300-Ohm
FlatTwin
Lead
Optional 300-Ohm
to 75-Ohm
Matching Transformer
75-Ohm
Coaxial
Cable
TV back panel (section detail)
3.
2.
1.
Figure 3. Connecting an Antenna
Mitsubishi strongly recommends against using
antennas with twin flat leads. Twin flat lead
antenna wires are subject to interference which
may adversely affect the performance of the TV.
We recommend using coaxial antenna cable.