MITSUBISHI ELECTRIC WS-55815 - Manual (Page 49)

48 49
To record a current program, press REC (record) when
your program choice is highlighted on ChannelView’s
the program list. A red “R” will be added to the left of
the program time. The TV will immediately switch to
the selected channel and start recording.
To record a future program, press ADJUST or
to select the channel you want to record from. Press
INFO to see the upcoming programs for that channel.
Press ADJUST or to move to your program
choice. Press REC (record) when your choice is
highlighted in ChannelView. A red “R” will be added
to the left of the program time. The message, “The
recording has been added to the Record List” will
display. To view, change or cancel the recording, use
the Record List (page 51). The program you selected
will be on that list and if digital, will be recorded on the
default device you selected in the NetCommand menu.
Device Selection Menu
For compatible traditional VCRs, pressing GUIDE when
the VCR is highlighted on the Device Selection menu
will change the VCR’s input. When the A/V Receiver
icon is highlighted in the Audio Section, pressing
GUIDE switches the A/V Receiver from analog audio to
digital audio and vice versa.
Record To Menu
When in the Record To menu, pressing GUIDE will
display the current programmed recordings. Please
see Record List, page 51 for more infomation.
Using the GUIDE Button to Display ChannelView™ and Menus
For complete ChannelView information to be
refreshed daily, the TV must be powered Off
between 5 to 15 minutes a day, depending on the
number of channels in memory. If the TV loses
power, the program listings will be temporarily
lost.
IMPORTANT
Devices (1394 or IR Controlled)
For NetCommand compatible satellite receivers and
some cable boxes, GUIDE will display the on-screen
programming guide for the receiver or cable box.
Press ADJUST , , or and ENTER to navigate
the displayed Guide. For NetCommand compatible
satellite receivers, you may also be able to use the
number or other additional buttons.
For NetCommand compatible DVD players, GUIDE will
display the DVD disc “top” menu (not the setup menu).
For A/V Discs, pressing GUIDE will display the Track
List screen
For IEEE 1394 devices with digital connections, press
GUIDE twice to display the device’s Guide.
ChannelView
Figures 6 and 7
Press GUIDE while viewing Ant-1 or Ant-2 to display
a list of available memorized digital channels
and memorized analog channel information (if
available from the broadcaster). This list is called
ChannelView™.
ChannelView for digital channels will show the major
and sub-channels (or bitstreams). The currently
viewed channel will be highlighted in the list. Analog
channel information will display as sent. Press
ADJUST or to page through the all the channels
in memory, one by one. To page through the choices
quickly, press CH or .
The information on this screen is sent by the
broadcaster. If limited data is shown or no program
data appears, it is because of limitations from the
broadcaster. This is not a defect of your TV. See
Troubleshooting for possible solutions.
Figure 6. ChannelView screen, current programs
Figure 7. ChannelView screen, future programs
The GUIDE Button
Depending on the device you are currently viewing, pressing GUIDE allows you to see different program guides or
menus.