Multiquip StreetPro Professional Pavement Saw SP118 - Manual (Page 23)

Sp118 pavemenT Saw • operaTion manual — rev. #1 (05/03/12) — page 23
3. Check V-belt tension by using a tension meter (3.0
lbs./1.36Kg) against the inside belt at a mid point
between the two pulleys, or by deflecting the center
belt at a mid point 3/16" (5 mm).
Figure 9. V-Belt Alignment
4. Do noT over or under tighten the V-belts. Severe
damage can occur to the saw and engine crankshaft
if the belt is over-tensioned. A decrease of power to
the blade and poor performance will result if the belt
is under-tensioned (loose on pulleys).
NOTICE
V-belt alignment must be rechecked after adjusting
belt tension.
SpeCiFiC ToolS To Be uSeD
This saw is to use tools (blades) as follows:
„ Steel Core Segmented or Continuous Diamond Rim
Cutting Wheel.
Any other type of tool is not to be used. See Table 6 for
specific blade usage for material.
warning
Failure to thoroughly inspect the diamond
blade (Figure 10) for operational safety
could result in damage to the blade or
the saw, and may cause injury to the user
or others in the operating area. Discard
damaged or worn blades and replace with fresh
blade.
inSpectiOn/Setup