Multiquip StreetPro Professional Pavement Saw SP118 - Manual (Page 20)

page 20 — Sp118 pavemenT Saw • operaTion manual — rev. #1 (05/03/12)
baSic enGine
Figure 4. Engine Components
The engine (Figure 4) must be checked for proper
lubrication and filled with fuel prior to operation. Refer to
the manufacturers engine manual for instructions & details
of operation and servicing.
1.
Fuel Filler Cap — Remove this cap to add unleaded
gasoline to the fuel tank. Make sure cap is tightened
securely. Do noT over fill.
2. Throttle lever — Used to adjust engine RPM speed
(lever advanced forward Slow, lever back toward
operator FaST).
3. engine on/oFF Switch —on position permits engine
starting, oFF position stops engine operations.
4. recoil Starter (pull rope) — Manual-starting method.
Pull the starter grip until resistance is felt, then pull
briskly and smoothly.
Danger
Adding fuel to the tank should be done
only when the engine is stopped and has
had an opportunity to cool down. In the
event of a fuel spill, Do noT attempt to
start the engine until the fuel residue has
been completely wiped up, and the area surrounding
the engine is dry.
5. Fuel valve lever — open to let fuel flow, CloSe to
stop the flow of fuel.
6. Choke lever — Used in the starting of a cold engine,
or in cold weather conditions. The choke enriches the
fuel mixture.
7. air Cleaner — Prevents dirt and other debris from
entering the fuel system. Remove wing-nut on top of
air filter cannister to gain access to filter element.
8. Spark plug — Provides spark to the ignition system.
Clean spark plug once a month.
9. muffler — Used to reduce noise and emissions.
10. Fuel Tank — Holds unleaded gasoline. For additional
information refer to engine owner's manual.
NOTICE
Operating the engine without an air filter, with a
damaged air filter, or a filter in need of replacement
will allow dirt to enter the engine, causing rapid engine
wear.
warning
Engine components can generate extreme heat. To
prevent burns, Do noT touch these areas while the
engine is running or immediately after operating. never
operate the engine with the muffler removed.