MITSUBISHI ELECTRIC VS-50111 - Manual (Page 70)

70 70
A
pp
en
di
x E
: D
ia
m
on
d S
hi
el
d I
ns
tr
uc
tio
ns
Appendix E: Diamond Shield Instructions
Follow the steps below to install and remove the
Diamond Shield™
INSTALLATION
Note: Included in the Diamond Shield™
package are the following items:
(1) Diamond Shield™
(2) Molding Clips
1 Carefully remove the Diamond Shield™ from its
protective packaging. Wipe off any dust with a lint-free
cloth.
2 Begin by inserting the shield, sliding it into the
channels, starting at the bottom. Gently bow the
Diamond Shield™ toward you and insert the
Diamond Shield™ into the top channel.
3
Install the left and right molding clips by pressing
them into the opening starting at a corner. Do not
force the clip. The clip will slide into place. This
completes the Diamond Shield™ installation.
REMOVAL
To remove the Diamond Shield™, reverse the order of
the above procedure.
Diamond Shield™ Installation and Removal Procedure
(WS-48311)
IMPORTANT:
The WT-42311 Diamond Shield is
not designed to be removed by
the Customer.
3
2