Millennium Enterprises GME-P100 - Manual (Page 25)

HYDRATION SYSTEM
The hydration system is NOT approved in
a CBRN application and must NOT be
used. Failure to follow this warning can
result in serious personal injury or death.
In an Industrial application only:
1. Return to an uncontaminated area
before using the hydration system.
2. Grasp the knurled sur-
face of the tube and
pull the tube out of its
cover (part of the
exhalation valve cover)
3. Hold the tube with its inlet end up.
4. Push the tube inlet into
the "NATO" canteen
inlet.
5. Turn the canteen
upside down. Its
contents will flow
by gravity.
6. Grasp the exhalation valve cover and
press in at the top while pushing out at
the bottom of the cover. This positions
the drink tube outlet toward your lips.
7. After drinking, disengage the tube from
the canteen and stow it in the exhalation
valve port.
Refer to the NIOSH Approval Matrix for a
complete list of approved accessories. If
you must wear corrective eyewear, install
an approved spectacle kit, listed on the
NIOSH Approval Matrix insert.
The accessories include:
• ESPII Communication System
• Spectacle Kits
• Butyl Coated Nylon Hood
• Lens Outsert
User's Instructions for installation and use
of the ESP II Communication System and
Spectacle Kit are enclosed with the acces-
sory.
INSTALLATION OF OUTSERT ASSEMBLY
Install an outsert over the facepiece lens
1. Line up the outsert
tabs and centerline
mark with the face-
piece lens.
2. Slide the outsert tabs down over the top
of the facepiece lens.
3. Stretch the band down
and under the face-
piece voice-mitter.
25 TAL 403 (L) Rev. 4 - 430351
ACCESSORIES
CAUTION
!
WARNING
!