Memorex MT3010OM - Manual (Page 24)

TV OPERATION
23
Adjust the volume level by pressing the VOLUME UP ❶ or
DOWN ❷ button. The volume level will be indicated on the
screen by a green numerical display between 0 and 100
where 0 is the lowest setting and 100 is the loudest.
1 2
3
For proper operation, before selecting channels, they
must be set into the TV’s program memory, see page 19.
Press and release the CHANNEL UP ❶ or DOWN ❷ button.
The TV automatically stops at the next channel set into
memory. This will not operate if channels are not set into
memory.
Direct Program Selection buttons (0 - 9, 100+)
Use these buttons to select a channel. The channel number
will appear at the top right corner of the screen.
• For Channels 01 through 99, press the two digits in order.
• For Channels 100 through 125, press the 100 button ❸,
then the remaining two digits.
1
2
3
4
Set the AIR/CABLE option as described on page 18.
2
Press the POWER button to turn on the TV; the POWER
indicator will light green.
1
OPTIONS
AIR: If using a
VHF/UHF
antenna.
CABLE: If using Cable
TV.
NOTES:
• When TV/CATV is set to TV, only channels up to 69
can be selected. When set to CATV, channels up to
125 can be selected.
• If an invalid channel is selected, the display will revert
to the original channel.
FAQs:
Why do I only receive 69 channels, when my cable goes much higher?
AIR/CABLE option must be set to CABLE when using cable, see page 18.
Why are some channels scrambled?
You must subscribe to these channels through your cable company.