Philips Magnavox 32MF338B - Manual (Page 9)

9
EN
P
REPARATION
WATCHING TV
INTRODUCTION
PREPARATION
INITIAL SETTING
OPTIONAL SETTING
TROUBLESHOOTING
INFORMATION
Basic Connection
This section describes how to connect the unit to an antenna, cable receiver or satellite box.
Note:
• Be sure your antenna or other device is connected properly before plugging in the AC power cord.
[Antenna Connection]
Connect the RF coaxial cable on your home outlet to the antenna input jack of this TV.
e.g.)
Once connections are completed, turn on the TV and begin initial setup. Autoprogram is necessary for the TV to
memorize all available channels in your area. (Refer to “Initial Setup” on page 14.)
Note:
• If you have any question about the DTV’s antenna, visit www.antennaweb.org for further information.
• For your safety and to avoid damage to this unit, please unplug the RF coaxial cable from the antenna input jack before moving the unit.
• If you use an antenna to receive analog TV, it should also work for DTV reception. Outdoor or attic antennas will be more effective than
settop versions.
• To switch your reception source easily between antenna and cable, install an antenna selector.
• If you connect to the cable system directly, contact the CATV installer.
[Connection to Cable Receiver or Satellite Box]
Use an HDMI or the component video cable to connect the HDMI or the component video input jacks of the TV to the
HDMI or the component video output jacks of the cable receiver / satellite box.
If you connect to the TV’s COMPONENT1 or COMPONENT2 video input jacks, connect an audio cable to the audio L/R
jacks of COMPONENT1 or COMPONENT2 accordingly.
COMPONENT 1 COMPONENT 2 VIDEO 1
S-VIDEO
VIDEO
Y
Pb
Pr
Y
Pb
Pr
AUDIO
R
L
AUDIO
R
L
AUDIO
R
L
AUDIO
R
L
DIGITAL AUDIO OUT (COAXIAL)
AUDIO
HDMI-IN
PC-IN
COMPONENT VIDEO OUT
Pr/Cr Pb/Cb Y
AUDIO OUT
R L
STEREO PCM
HDMI OUT
ANT IN
You can also connect this TV to the cable receiver or satellite box other than the HDMI or the component video
output jacks because they might have different output jacks.
Required cables and connecting methods of the cable receiver / satellite box, or the availability channel for the clear
QAM may differ depending on the cable/satellite provider. For more information, please contact your cable/satellite
provider.
5
*
*
*
Cables not included.
Please purchase the necessary cables at your local store.
VHF / UHF
antenna
RF coaxial cable
or
cable TV signal
rear of this TV
satellite dish
(red) (red) (blue) (blue) (green) (green)
(red) (red)
(blue) (blue)
(green) (green)
cable receiver / satellite box
cable TV signal
including PPV
or
rear of this TV
HDMI cable
or
or
component video cable
and audio cable
RF coaxial
cable
e.g.)
(red) (blue) (green)
(red)
(blue)
(green)