Philips Magnavox 32MF338B - Manual (Page 21)

21
EN
O
PTIONAL SETTING
WATCHING TV
INTRODUCTION
PREPARATION
INITIAL SETTING
OPTIONAL SETTING
TROUBLESHOOTING
INFORMATION
Channel List
The channel list function lets you remove undesired channels from the
channel registration list.
1
Press [MENU] to display the main menu.
2
Use [Cursor K / L] to select “SETUP”, then press [OK].
PICTURE
SOUND
SETUP
FEATURES
LANGUAGE
EXIT
Channel List
Add Channels
Antenna
Autoprogram
3
Use [Cursor K / L] to select “Channel List”, then press
[OK].
PICTURE
SOUND
SETUP
FEATURES
LANGUAGE
EXIT
Channel List
Add Channels
Antenna
Autoprogram
4
Use [Cursor K / L] to select the channel you want to
remove, then press [OK].
PICTURE
SOUND
SETUP
FEATURES
LANGUAGE
EXIT
Ch Select Watch/Skip Back BACK
OK
Highlight channels for Ch Up/Down key
selection.
61
62
70
40
37
50
60
DTV
DTV
DTV
DTV
The channel display for the removed channel
darkens. You will not be able to select the channel
again using [CH. / ].
To reactivate a removed channel, use [Cursor K / L] and
press [OK]. The registered channels are highlighted.
When you remove a major channel, its minor
channels are removed as well.
Note:
• The channel with the “DTV” indicated on the display is
ATSC. Otherwise the channel is NTSC.
5
Press [MENU] to exit.
5
•
•
•
Add Channels
This function lets you add the channels that were not added by the
autoprogram due to the reception condition at the initial setting.
1
Press [MENU] to display the main menu.
2
Use [Cursor K / L] to select “SETUP”, then press [OK].
PICTURE
SOUND
SETUP
FEATURES
LANGUAGE
EXIT
Channel List
Add Channels
Antenna
Autoprogram
3
Use [Cursor K / L] to select “Add Channels”, then press
[OK].
PICTURE
SOUND
SETUP
FEATURES
LANGUAGE
EXIT
Channel List
Add Channels
Antenna
Autoprogram
4
Use [the Number buttons] to enter the number of the
channel you want to add, then press [OK].
10
PICTURE
SOUND
SETUP
FEATURES
LANGUAGE
EXIT
For analog channels, select a channel to
be added using number keys.
For digital channels, you must perform
Autoprogram function.
Add channel
Ch Change Back BACK
5
Press [MENU] to exit.
Note:
• When “Added to the channel list” is displayed, it has been
set-up completely.
• It just allows you to change this register when watching TV
program.
5