Philips Magnavox 32MF338B - Manual (Page 14)

14
EN
I
NITIAL SETTING
Initial Setup
This section will guide you through the TV’s initial setting which includes
selecting a language for your on-screen menu and autoprogram, which
automatically scans and memorizes viewable channels.
Before you begin:
Make sure if the TV is connected to antenna or cables.
1
After making all the necessary connections, press
[POWER y
y ] to turn on the TV.
This operation may take a few moments.
2
Use [Cursor K / L] to select the on-screen language
from the choices on the right side of the TV screen.
(English / Español / Français)
Initial Setup Initial Setup
Select the language for setup display.
Elija el idioma de ajuste.
Sélectionner langue écran config.
Select Exit MENU OK OK
Français
Español
English
“Initial Setup” menu on step 3 will be displayed in the
selected language after you press [OK].
3
Use [Cursor K / L] to select “Air” for TV channels or
“Cable” for CATV channels, then press [OK].
Initial Setup Initial Setup
Select Back BACK
Make sure the antenna is connected to "ANT.IN" jack.
Select your signal source.
Air
Cable
ANT.IN
Or
Exit MENU OK OK
Cable
Air
Scanning and memorizing of channels start
automatically.
Initial Setup Initial Setup
Now the system is scanning for channels, please wait.
2%
Analog channels 0 ch
Digital channels 0 ch
Exit MENU
When the scanning and memorizing of channels are
completed, the lowest memorized channel will be
displayed.
5
•
•
•
•
Note:
• If you connect the cable system directly, contact the CATV
installer.
• If you press [POWER y y ] or [MENU] during autoprogram,
this setting will be canceled.
• The initial autoprogram function can be executed for
either “Air” or “Cable” only once. When you change the
connection (Air/Cable), set autoprogram again. (Refer to
page 15.)
• You can cancel or exit the initial autoprogram menu by
pressing [MENU].
• If there is no signal input from the antenna terminal and
no operation for several seconds after you turn on the TV,
“Helpful Hints” appears. Follow the instructions listed on
the TV screen.
No channel is registered.
Press and hold "OK" key on the remote control for 3 seconds.
Contact support hotline provided on manual or back of unit.
Sin canal registrado.
Pulse durante 3 segundos la tecla "OK" en el control remoto.
Llame teléfono de apoyo en manual o atrás de TV.
Pas de chaîne consign.
Enfoncez "OK" 3 secondes sur la télécommande.
Contacter numero d'urgence dans manuel ou arrière appareil.
These operations are accessible by remote control. Some may also be accessible by controls on the main TV.