Philips Magnavox 32MF338B - Manual (Page 15)

15
EN
WATCHING TV
INTRODUCTION
PREPARATION
INITIAL SETTING
OPTIONAL SETTING
TROUBLESHOOTING
INFORMATION
Main Menu
This section describes the overview of the main menu displayed when you
press [MENU]. For more details, see the reference page for each item.
The main menu consists of the function setting items below.
Press [MENU].
PICTURE
SOUND
SETUP
FEATURES
LANGUAGE
EXIT
EXIT
To exit settings.
PICTURE
You can adjust the picture quality.
(Refer to “Picture Adjustment” on page 23.)
SOUND
You can adjust the sound quality.
(Refer to “Sound Adjustment” on page 24.)
SETUP
You can automatically scan the viewable channels and
remove the undesired channels.
(Refer to “Autoprogram” on page 15.)
FEATURES
You can change the display format for closed caption,
which displays the dialogue of a TV program or other
information across the TV screen.
(Refer to “Closed Caption” on page 25.)
You can set the viewing limitations.
(Refer to “Parental Control” on page 29.)
You can adjust the position, stability and clarity of the
PC screen.
(Refer to “PC Settings” on page 32.)
You can select the sound input for the HDMI1 input
jack if your TV is connected to an HDMI or DVI device.
(Refer to “HDMI Audio” on page 33.)
LANGUAGE
You can change the language (English, Spanish,
French) displayed on the main menu.
(Refer to “Language Selection” on page 16.)
5 Autoprogram
If you switch wires (e.g., between antenna and CATV) or if you move the TV
to a different area after the initial setting, or if you restore the DTV channel
you deleted, you will need to perform autoprogram.
Before you begin:
Make sure if the TV is connected to antenna or cables.
1
Press [MENU] to display the main menu.
2
Use [Cursor K / L] to select “SETUP” , then press [OK].
PICTURE
SOUND
SETUP
FEATURES
LANGUAGE
EXIT
Channel List
Add Channels
Antenna
Autoprogram
3
Use [Cursor K / L] to select “Autoprogram”, then press
[OK].
PICTURE
SOUND
SETUP
FEATURES
LANGUAGE
EXIT
Channel List
Add Channels
Antenna
Autoprogram
Use [Cursor K / L] to select an appropriate option, then
press [OK].
PICTURE
SOUND
SETUP
FEATURES
LANGUAGE
EXIT
Air
Cable
Digital Cable
Back
Autoprogram will rescan all channels.
This may take a while to complete.
Select your signal source.
Air
Cable Or
ANT.IN
When aerial antenna is connected, select “Air”.
When connected to CATV, select “Cable”.
Scanning and memorizing of channels start
automatically.
Exit
MENU
75%
Analog channels 10 ch
6 ch Digital channels
Now the system is scanning for channels, please wait.
When the scanning and memorizing are completed,
the lowest memorized channel will be displayed.
5
•
•
•
•