Manitowoc Ice Q - Manual (Page 38)

Maintenance Section 4
4-2 Part Number 000001530
Step 6 Remove parts for cleaning.
A. Remove the splash shield
• Pull forward on left and right nylatch connectors until
disengaged from ice machine (connectors remain
attached to splash shield).
• Remove panel from front of ice machine by lifting
forward and up.
B. Remove the water curtain
• Gently flex the curtain in the center and remove it
from the right side.
• Slide the left pin out.
Water Curtain Removal
C. Remove the ice thickness probe
• Compress the hinge pin on the top of the ice
thickness probe.
Ice Thickness Probe Removal
• Pivot the ice thickness probe to disengage one pin
then the other. The ice thickness probe can be
cleaned at this point without complete removal. If
complete removal is desired, disconnect the ice
thickness control wiring from the control board.
! Warning
Disconnect the electric power to the ice machine at
the electric service switch box..
Important
Splash Shield must be reinstalled to prevent water
leakage.
NYLATCH CONNECTORS
PULL FORWARD TO
DISENGAGE SV1771A
SV3135
COMPRESS
HINGE PIN TO
REMOVE