Marantz VP8600 - Manual (Page 28)

23
ENGLISH
❖
Problem: There is no light from the projector
1. Check that the power cable is securely connected.
2. Ensure the power source is good by testing with another electrical device.
3. Restart the projector in the correct order and check that the Power LED is blue.
4. Have the lamp module replaced.
❖
Problem: The lamp goes off
1. Power surges can cause the lamp to turn off. Press the power button to turn off the
projector. When the Lamp Ready LED is on, press the power button.
2. Have the lamp module replaced.
❖
Problem: The projector does not respond to the remote control
1. Direct the remote control towards remote sensor on the projector.
2. Ensure the path between remote and sensor is not obstructed.
3. Turn off any fluorescent lights in the room.
4. Check the battery polarity.
5. Replace the batteries.
6. Turn off other Infrared-enabled devices in the vicinity.
7. Have the remote control serviced.
If you are unable to solve the problem, you should have the projector serviced. Pack the
projector in the original carton. Include a description of the problem and a checklist of the
steps you took when trying to fix the problem. The information may be useful to the service
personnel. Return the projector to the place you purchased it.
Having the Projector Serviced
Remote Control Problems
Lamp Problems