Marantz VP8600 - Manual (Page 13)

You can connect this projector to HD-Video /PC using RGB IN port, or DVD Player/Satellite
/Cable Tuner /PC using DVI-D IN port.
1. Connect one end of the RGB cable to the RGB IN port, or one end of the DVI-D cable to
the DVI-D IN port on the projector.
2. Connect the other end to the corresponding port on a HD-Video, Satellite, Cable Tuner or
personal computer.
Note : When projecting a video image from a device connected to the DVI-D terminal,
follow the procedure below.
1. Turn on power of this unit.
2. Set the input video source to DVI-D input.
3. Turn on power of the device connected to the DVI-D terminal of the unit (i.e. DVD
player).
If the procedure above is not followed, projected image may corrupt.
For the details of the DVI-D terminal on the device connected with the unit, see the
instruction manual of the device.
Connection with a HD-Video, DVD Player, Satellite, Cable Tuner or PC
RGB OUT
or
DVI-D out
RGB OUT
or
DVI-D out
RGB (D-Sub monitor) cable
(commercially available)
HD-Video / Satellite /
Cable Tuner / DVD Player
Monitor output
IBM VGA or
Compatible PC
RGB out
or
DVI-D out
or
HDMI out
DVI-D cable
(commercially available)
RGB out
or
DVI-D out
8
ENGLISH
COMPONENT 1: SCART
When connecting the COMPONENT 1 terminal to the SCART (RGB) out terminal, set
COMPONENT 1 settings to [SCART]. (
☞
P.19)
FL OFF STANDBY
SCART CONNECTOR
DVD Player
Scart to RGBCS cable
(commercially available)
PC
MONITOR OUT
V H R B G
5RCA cable
(commercially available)
COMPONENT 1: RGB
When connecting the COMPONENT 1 terminal to the RGB HV out terminal, set
COMPONENT 1 settings to [RGB]. (
☞
P.19)