Motorola XTL446 - Manual (Page 12)

E
nglish
12
Simple Menu Mode
Simple Menu mode allows you to limit the number of
menus displayed (Channel, Code and call tones) to
allow for simpler radio operation.
1.To enable Simple Menu mode press
H
as you turn
on the radio. The radio chirps and the display tempo-
rarily displays only 6 images.
2.To turn off Simple Menu mode press
H
as you
turn on the radio.
Selecting a Radio Channel
1.Press H . The channel number will begin to flash.
2.Use
D
or
l
to change channel.
3.Briefly press
G
to set new channel or press and
hold H for 3 seconds to exit menu.
Interference Eliminator Code
Interference eliminator codes help minimize
interference by providing you with a choice of code
combinations.You can specify a different code for each
channel.
1.Press
H
until the code number begins to flash.
2.Use
D
or
l
to change the code.To hear every-
one on your channel, select code 0.
3.Press
G
to set new code.
You can specify a different code for each channel:
1.To set a channel and code combination, press
H
and then press
D
or
l
to select the channel.
2.Press
H
again and then press
D
or
l
to
select a code.
3.Press
G
or press and hold
H
to exit the menu
and to save the channel and code combination.
Keypad Tones
Every time you press a button on your radio, it beeps
unless you turn this function off. Your radio is
programmed at the factory with keypad tones turned
on.
1.To disable the tones, hold down
l
while switching
on your radio. When you press any button on the
keypad you will no longer hear the tone.
2.To enable tones, hold down
l
while switching on
your radio.
Scan
Use this facility to monitor other transmitting radios. It
allows you to listen and talk back without having to
change channels.
1.To start scanning, briefly press
J
. The scan indica-
tor h will be displayed and the radio scrolls through
available channels. When the radio detects activity, it
stops on that channel and displays the channel num-
ber and code.
6864225V01_O_EN.fm Page 12 Thursday, September 16, 2004 3:50 PM