Multi-Tech Systems MT5600SMI-34 - Manual (Page 52)

Chapter 5 – AT Commands, S-Registers, and Result Codes
Multi-Tech Systems, Inc. SocketModem MT5600SMI Developer’s Guide 52
and
Numeric values which specify the lowest
() and highest () rate at
which the modem may establish a transmit connection.
Non-zero values for this subparameter are decimal
encoded, in units of bit/s. The possible values for each
modulation are listed in Table 5-3.
Actual values will be limited to possible values
corresponding to the entered and fall-back
as determined during operation. (Default =
lowest () and highest ()
rate supported by the selected carrier.).
Report Commands: +MS? Reports current rates
Response: +MS:,,,
, ,
Note: The current active settings are reported under control of
the +MR parameter.
Example: +MS: K56, 1,300,33600,300,56000
For default values. This example allows maximum system
flexibility to determine optimal receive and transmit rates
during operation.
+MS=? Reports supported range of parameter values:
Response: +MS: (< carrier> range),(
range),( range), ( range),
( range), ( range)
Example 1:
+MS:(B103,B212,V21,V22,V22B,V23C,V32,V32B,V34,
K56,V90),(0,1),(300-33600),(300-33600),(300-56000),(300-
56000)
Example 2:
+MS:(B103,B212,V21,V22,V22B,V23C,V32,V32B,V34,
V90,V92),(0,1),(300-33600),(300-33600),(300-56000),(300-
56000)
Result Code: OK - Valid subparameter string
Otherwise ERROR