Motorola WR850GP - Manual (Page 60)

Configuration Section 3
WR850 3-27
FILTERS Page – All Configuration Options
Field Description
LAN MAC Filter
Mode:
(ADVANCED)
Sets whether local network clients (specified by MAC address) are
allowed or denied access to your broadband connection.
• Selecting Allow will allow access only by the clients identified
by the Filtered LAN MAC Addresses below.
• Selecting Deny will deny access by the clients identified by
the Filtered LAN MAC Addresses below.
• Selecting Disabled will suppress all MAC address filtering,
and allow all clients access to your broadband connection.
FACTORY DEFAULT:
Deny
Filtered
LAN MAC
Addresses:
(ADVANCED)
Sets a list of up to 10 LAN clients (specified by MAC address) from
which communications are filtered as per the LAN MAC Filter Mode.
NOTE: A MAC address has a format of: XX:XX:XX:XX:XX:XX.
FACTORY DEFAULT:
(blank)
LAN Usage
Filters:
(ADVANCED)
Sets rules whereby LAN clients (specified by IP address) are not
allowed access to certain port ranges during specified times. For
example, clients might be temporarily blocked from Internet use.
NOTE: These settings are only used if Operation Mode on the BASIC
Page is set to Router.
You can store up to 20 filtering rules, and selectively enable one or
more of them when desired, using the Enabled checkbox at the end
of each row.
NOTE: Filtering rules will be applied in the order in which they are listed
on this page.
For each filtering rule, the following 5 items must be entered:
(1) LAN IP Address Range:
These two fields define a range of LAN clients to which the filtering
rule will apply. To apply a rule to a specific client, enter the same IP
address in both fields.
FACTORY DEFAULT:
(blank)
(2) Protocol:
This field specifies the Internet communication Protocol that will be
restricted as per the filtering rule.
(continued on next page)