Motorola WR850GP - Manual (Page 46)

Configuration Section 3
WR850 3-13
Field Description
Default
Gateway:
(ADVANCED)
Sets the IP address of the default gateway for the WR850
connections, when the Protocol field is set to Static.
The default gateway is set by default to be the WR850 (i.e., the
factory default IP address matches that of the WR850).
NOTE: If Protocol (above) is set to DHCP, this field will be greyed out,
and any data entered will not be used.
FACTORY DEFAULT:
192.168.10.1
Options related to:
ENABLING THE WR850 BUILT-IN DHCP SERVER
Field Description
DHCP Server:
(ADVANCED)
Sets the method by which IP addresses are assigned to devices that
interface with the WR850 via the LAN connections (or “clients”).
• Selecting Enabled engages the Dynamic Host Configuration
Protocol (DHCP) server, which can dynamically assign (or
“lease”) IP addresses to clients.
• Selecting Disabled disengages the DHCP server, requiring
that you manually assign unique and permanent (or “static”)
IP addresses to clients.
NOTE: The built-in DHCP Server is a router function. Therefore, this
field, and the related DHCP Server fields below, are disabled or
ignored if the Operation Mode on the BASIC Page is set to
Access Point.
NOTE: You will need to disable the DHCP Server, and assign static IP
addresses, if you wish to use features on the ROUTING Page.
FACTORY DEFAULT:
Enabled
DHCP Starting
IP Address:
(ADVANCED)
Sets the start of the IP address range that the DHCP server will
lease to clients.
NOTE: This field is ignored if the DHCP Server (above) is Disabled.
FACTORY DEFAULT:
192.168.10.2