Installation instructions – Stovax Steel Manhattan Log Effect Stove Range User Manual

Page 13

5.4 Place log D across from the rear log A to log B on the left-

hand side. There are cut-outs in both logs for location. See

diagram 13.

5.5 There are two ash panels which lay across the front of the

burner skin. Place the panel with the flat edge facing the left

side of the firebox. There are location holes on this log

which fit over the screw holes of the burner skin.

5.6 Place the second ash panel to the right of the first, with the

pointed end of the panel fitting into the V shape. This panel

should locate on the screw holes of the burner skin. Ensure

that both logs are horizontal to the burner ports.

5.7 Place log E across from the rear of log A to log C on the

right-hand side. Again, there are cut-outs for location. The

front of the log should sit on the front ash panels and should

fit tight to log C. See diagram 16.

5.8 Carefully insert the front coal retainer into the front panel of

the firebox. Take care not the scrape/damage the logs. This

coal retainer sits in two brackets. Ensure it is fully inserted,

leaving approximately a 4 mm gap between the firebox

ledge and the bottom of the coal retainer.

5.9 Ensure that the rope seal on the back of the glass frame is

intact. Replace the glass frame making sure that the 8 screws

are tightened evenly. Do not overtighten. See Diagram 18.

INSTALLATION INSTRUCTIONS

AR0877

AR1613

AR1614

AR1615

AR1616

AR1617