Gateway E-4300 - Manual (Page 67)

61 www.gateway.com
Closing the case
To close the case:
1
Make sure that all of the internal cables are arranged inside the case so they will not
be pinched when you close the case.
2
Align the tabs on the front of the panel into the case notches.
3
Swing the side panel toward the case until it is flush with the side of the case.
4
Replace the thumbscrews.
5
Reconnect the cables and power cord.
Removing the front bezel
Some upgrading procedures may require you to remove the front bezel.
To remove the front bezel:
1
Open the case by following the instructions in “Opening the case” on page 60 .
2
In the lower front area of the case, press the two bezel retention tabs outward until
the lower part of the bezel detaches from the case.