GE 25880 - Manual (Page 27)

27
NOTE: If you make a mistake, press the delete button on the base or del/chan on
the handset to backspace and erase the wrong character(s) or number(s).
6. Use the touch-tone pad to enter the area code followed by the telephone
number (up to 24 digits, including pauses) and press the memory/
conference button again to save your selection. The unit beeps to confirm.
7. To enter another name and number in a different memory location,
return to step 1 and repeat the process.
S
TORING A
R
EDIAL
N
UMBER
1. Make sure the phone is OFF (not in TALK mode).
2. Repeat step 1 through 6 in Storing a Name and Number in Memory.
3. Press redial to display the redial number and name.
4. Press memory/conference again to confirm.
NOTE : If the number you want to redial has more than 24 digits, the
telephone number cannot be stored in memory.
I
NSERTING A
P
AUSE IN THE
D
IALING
S
EQUENCE
Press the #pause button on the touch-tone pad twice to insert a delay in
the dialing sequence of a stored telephone number when a pause is
needed to wait for a dial tone (for example, after you dial 9 for an outside
line, or wait for a computer access tone.) Each pause counts as 1 digit in
the dialing sequence.
R
EVIEWING
, C
HANGING OR
D
ELETING
S
TORED
N
AMES
/N
UMBERS
To Review: Press memory/conference on the handset or on base, then
press the caller ID (rev or skip) button (on base) or the caller ID/vol (- or +)
button (on cordless handset) to scroll through the stored numbers. Or
press the memory location number.
To Change: Follow the steps under Storing a Name and Number in Memory
except replace the stored name or number with the new information.
To Delete: Press memory/conference on the handset or on base, then press
the caller ID (rev or skip) button (on base) or the caller ID/vol (- or +) button
(on cordless handset) to scroll to a desired memory.