GE 21029 - Manual (Page 33)

33
• Press the cid/vol () button to review the newest call and scroll to older
calls (lower numbers).
2. Press the TALK/END/call back or SPKR buttons. The number dials
automatically.
If you get a busy signal and want to keep dialing the number, press the
REDIAL button to quickly redial the number.
Exit
Press the *exit button to exit a menu function and return to the standby
screen.
Page
The page feature helps you locate a misplaced handset. To send and receive
pages, all handsets must be registered. If your handset is not registered,
follow the instructions in the Registration section of this manual.
Handset to Handset Paging
Handsets are named HANDSET 1, HANDSET 2, and HANDSET 3
respectively.
1. Make sure the phone is OFF (not in talk mode).
2. Press and release the page/int button on a handset. PAGING
EXTENSION? shows in the display.
3. Use the touch-tone pad to enter the handset number you want to page.
NOTE: If more than 2 handsets have been registered, you can page all
handsets by pressing 5.
4. To cancel the page, press the *exit button, or press the page/int button.
Or you may press TALK/END/call back on the receiving handset to enter
intercom mode.
Paging from the Base/Group Page
Use the base-only to page all registered handsets at the same time.
1. Press the PAGE button on the base. All handsets beep for two minutes,
and PAGING FROM BASE shows on each handset’s display.
2. To cancel the page, press the PAGE button on the base, or press the TALK/
END/call back button or the *exit button on each handset.