GE 21029 - Manual (Page 12)

12
NOTE: It is important to maintain the polarity (black and red wires) to
the jack inside the compartment as shown in the illustration. To ensure
proper battery installation, the connector is keyed and can be inserted
only one way.
2. Install compartment cover and snap into place.
3. Place the handsets in the charging cradles.
Allow handsets to charge for 16 hours prior to first use. If you don’t
properly charge the handsets, battery performance is compromised.
NOTE: If the battery is not properly installed in the handset, or if the
battery pack is not properly connected to the jack inside the battery
compartment. “NO BATTERY” shows in the display when the handset is
placed in the charging cradle.
Installing the Phone
Choose the best location to install your base and handset charge cradle.
Your base and handset charge cradle should be placed on a level surface
such as a desk or table top.
Installing the Handset Battery
NOTE: You must connect the handset battery before use.
1. Connect battery pack plug to jack inside compartment on base.
BLACK WIRE
RED WIRE
BATTERY
PRESS DOWN
FIRMLY