Grizzly G0671 - Manual (Page 30)

-28-
Model G0671/G0672/G0673 (Mfg. Since 1/13
Step 1. Decide Who Will Design
For most small-to-medium sized shops, you can
design and build the dust collection system your-
self without hiring engineers or consultants. We
have included some basic information here to get
you started on a dust collection system design.
if you have a large shop or must design a com-
plicated system, then we recommend that you
perform additional research beyond this manual,
or seek help from an expert.
Step 2. Sketch your Shop Layout
planning is the most important step when design-
ing a successful dust collection system.
Before you begin to draw your necessary layout
sketch, we recommend that you visit our Free
Workshop Planner available on our website at
www.grizzly.com.
our Workshop Planner will allow you to quickly
and easily draw and print a basic shop layout.
don't worry, non-grizzly brand machines can be
substituted with grizzly machines for layout pur-
poses.
Note: After you're finished, make sure to
save your layout for later modification.
your sketch only needs the basic details of the
shop layout, similar to
figure 23, including all
your current/planned machines and your planned
placement of the dust collector.
System Design
figure 23. initial sketch of shop layout.
Dust Collector
Step 3. Sketch a basic Duct Layout
For the next step, sketch how your machines will
connect to the dust collector. Consider these gen-
eral guidelines for planning an efficient system:
1. Machines that produce the most sawdust
should be placed nearest to the dust collector
(i.e. planers and sanders).
2. ideally, you should design the duct system
to have the shortest possible main line and
secondary branch ducts. see
figures 24 &
25 for ideas of good duct layouts vs bad duct
layouts.
figure 24. good duct layout.
Branch
Line Ducts
Main
Line Duct
GOOD
figure 25. Bad duct layout.
BAD