Grizzly G0671 User Manual
Page 24
-22-
Model G0671/G0672/G0673 (Mfg. Since 1/13
4. attach the four casters to the legs by thread-
ing them into the bottom of the legs, as
shown in
figure 11.
x4
figure 11. attaching casters.
Note: The Model G0673 is a three-phase
machine. If it is wired out of phase, the
machine may not function properly. Proceed
to
Test Run on Page 25 to determine if your
machine is wired in phase, then proceed to
Step 7.
The Models G0671 and G0672 are single
phase and cannot be wired out of phase. For
these models, continue below.
7. attach the inlet to the top of the impeller
housing with the #10-24 x 3/8" phillips head
screw, as shown in
figure 13.
5. With assistance, turn the entire assembly
over so that the casters rest on the floor.
6. use eight
5
⁄
16
"-18 x 1" hex bolts, (16)
5
⁄
16
" flat
washers, and eight
5
⁄
16
"-18 hex nuts to attach
each collector to the impeller housing with a
rubber gasket between the components, as
shown in
figure 12.
figure 13. inlet mounted on impeller housing.
phillips
head screw
Caster
leg
figure 12. Collector mounted to impeller
housing.
rubber gasket
Collector
5
⁄
16
"-18 x 1"
hex Bolt
5
⁄
16
"-18
hex nut
5
⁄
16
" Flat Washers
impeller
housing